|
|
|
Kto jest w sklepie?
Sklep przegląda 5795 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Szybko, sprawnie i tanio. Serwis godny polecenia. Będę polecał innym
 ;
Ogólnie jest OK, z wyjątkiem obrazu płyty głównej, który jest miejscami mało czytelny, ale można sobie poradzić.
;
Dokładna dokumentacja, pomogła w szybkiej naprawie telewizora. Dziękuję!
;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
HOW TO TAKE OUT FRONT GRILLE Please follow below steps to take out front grille if necessary such as when servicing. Remove the Grille from the chassis. 1. Set the up-and-down air direction louver to open position (horizontally) by finger pressure.
10.3. OUTDOOR UNIT
10.3.1. SELECT THE BEST LOCATION (Refer to �Select the best location� section) 10.3.2. INSTALL THE OUTDOOR UNIT
2. Open the three screw covers as shown in the illustration below.
� After selecting the best location, start installation according to Indoor/Outdoor Unit Installation Diagram. 1. Fix the unit on concrete or rigid frame firmly and horizontally by bolt nut. (ø10 mm). 2. When installing at roof, please consider strong wind and earthquake. Please fasten the installation stand firmly with bolt or nails.
3. Remove the five mounting screws. 4. Open the front panel and remove a mounting screw at the centre. (Refer Diagram below) 5. To remove the Grille, pull the lower left and right side of the grille towards you (slightly tilted) and lift it straight upwards (Two tabs on the top inside edge of the grille are clear of their slots).
10.3.3. CONNECTING THE PIPING
Connect Piping to Indoor Please make flare after inserting flare nut (locate at joint portion of tube assembly) onto the copper pipe. (In case of using long piping) Connect the piping � Align the center of piping and sufficiently tighten the flare nut with fingers. � Further tighten the flare nut with torque wrench in specified torque as stated in the table.
REMOTE CONTROL NO. SWITCH 1. When installing two air conditioners in one room, each air conditioner can be synchronized to the remote controller. 2. In order to operate separately, open the rear cover of one of the remote controller and set the switch to �B�. 3. Also, set the remote control No. switch to �B� in the corresponding indoor unit. (The switch is located in the control box-sub. of the indoor unit.) Connect the Piping to Outdoor Unit 1. Align the center of the piping and sufficiently tighten the flare nut with fingers. 2. Finally, tighten the flare nut with torque wrench until the wrench clicks. � When tightening the flare nut with torque wrench, ensure the direction for tightening follows the arrow on the wrench.
|
|
|
> |
|
